Strona
16
z
26
4.2.1. Washing programs.
Controller’s memory has capacity for 8 programs, with two programs for washing
the milking devices and two programs for washing the cooling devices pre-programmed.
The remaining 4 spots allow an installer to create programs adapted to the individual
needs of an user.
4.2.2. Modification and creation of programs.
The controller allows to modify factory programs according to the needs of the user.
It is also possible to create programs yourself (by the installer). Each program can have
a maximum of 50 steps with a duration of 1 sec. to 99 min. The programming method is
very simple and intuitive – it has been included in the graphic form in section 4.3.2.
Programming for the washing segment.
4.2.3. Protection in the event of a power failure.
Loss of power supply interrupts the execution of the activated washing program. When
the correct supply voltage returns, the program will start in the same place where it was
stopped. In the settings of this function (UAP parameter – see section 4.3.1. Table of
settings for the washing segment), it is possible to temporarily limit the possibility
of returning to the interrupted controller (in range from 1 h to 9 h).
4.2.4. Test mode.
This function allows moving successively to the next program steps without waiting for
the duration of the step to expire. The transition is made by pressing the appropriate
button. This function is only available to the installer.
4.2.5. Return to the factory settings.
In the event of making a mistake while setting the controller's work or finding an
incorrect operation of the controller (at any stage of its use), it is possible to return to
the factory settings (Pd0d parameter – see section 4.3.1. Table of settings for the
washing segment).
4.2.6. Manual activation of the vacuum pump or the stirrer.
The controller is equipped with a button enabling manual activation of the vacuum pump
or the stirrer, regardless of the button
, but depending from UPP parameter setting –
see section 4.3.1. Table of settings for the washing segment.
4.2.7. Program start function.
The program is started by manually pressing the button located on the front of the
controller.
