8
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
•
Do not cut off dead trees or similar hard objects.
Failure to do so may damage the tool.
012484
Hold the trimmer with both hands and pull the switch
trigger A or B and then move it in front of your body.
1
2
3
012485
As a basic operation, tilt the blades towards the trimming
direction and move it calmly and slowly at the speed rate
of 3 - 4 seconds per meter.
1
012486
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
012487
Attaching the chip receiver (optional accessory) on the
tool when trimming the hedge straight can avoid cut off
leaves’ being thrown away.
012488
To cut a hedge side evenly, it helps to cut from the bottom
upwards.
012489
Trim boxwood or rhododendron from the base toward the
top for a nice appearance and good job.
Installing or removing chip receiver
(optional accessory)
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before installing or removing chip
receiver.
NOTE:
•
When replacing the chip receiver, always wear
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
•
Always be sure to remove the blade cover before
installing the chip receiver.
•
The chip receiver receives cut-off leaves and
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
1
2
3
4
012493
1. Press
2. Chip receiver
3. Nut
4. Shear blade
1. String
1. Trimming
direction
2. Hedge surface
to be trimmed
3. Tilt the blades
