Makita LS1219/1, Инструкция по эксплуатации

Страница: 26 / 32

26 ENGLISH
WARNING:
Be sure to use flat stock as a
platform. Stock that is not flat may move during the
cutting operation which may result in kickback and
serious personal injury.
NOTE: The maximum cutting capacity in height will
be reduced by the same amount as the platform
thickness.
4.
Place the platform on the tool so that it extends
equally over each side of the tool base.
Secure the platform to the tool using four 6 mm wood
screws through four holes in the lower fences.
2
3
4
1
► 1. Screws (two each side) 2. Lower fence 3. Base
4. Platform
WARNING:
Make sure that the platform is lay-
ing flat against the tool base and secured firmly
to the lower fences using the four screw holes
provided. Failure to properly secure the platform may
result in movement and possible kickback resulting in
serious personal injury.
WARNING:
Ensure that the tool is firmly
mounted to a stable and flat surface. Failure to
properly mount and secure the tool could cause the
tool to be unstable resulting in a loss of control and/
or the tool falling which may result in serious personal
injury.
5. Install the upper fences on the tool.
WARNING:
Do not use the tool without upper
fences installed.
The upper fences provide the ade-
quate support required to cut the workpiece.
If the workpiece is not supported properly, it may
move resulting in possible loss of control, kickback
and serious personal injury.
6. Place the workpiece to be cut on the platform
secured to the tool.
7. Secure the workpiece firmly against the upper
fences with a vise before cutting.
1
2
3 4
► 1. Upper fence 2. Vertical vise 3. Workpiece
4. Platform
8. Make a cut through the workpiece slowly accord-
ing to the operation titled "Slide (push) cutting (cutting
wide workpieces)."
WARNING:
Ensure that the workpiece is
secured with the vise and make the cut slowly.
Failure
to do so may cause the workpiece to move resulting in
possible kickback and serious personal injury.
WARNING:
Be aware that the platform may
become weakened after several cuts are per-
formed at various miter angles. If the platform
becomes weakened due to the multiple kerf cuts left
in the material, the platform should be replaced. If the
weakened platform is not replaced, it may cause the
workpiece to move, during cutting, resulting in possi-
ble kickback and serious personal injury.
Carrying tool
Before carrying, make sure to unplug and all movable parts
of the miter saw are secured. Always check the following:
• The tool is unplugged.
• The carriage is at 0° bevel angle position and
secured.
• The carriage is lowered and locked.
• The carriage is fully slid to the guide fence and
locked.
• The turn base is at the full right miter angle posi -
tion and secured.
• The holders are stored and secured.
Carry the tool by holding both sides of the tool base as
shown in the figure.