10 ENGLISH
Tool / battery protection system
The tool is equipped with a tool/battery protection sys
-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto
-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Status
Indicator lamps
On
Off
Blinking
Overload
Overheat
Over
discharge
Overload protection
If the tool is overloaded by entangled branches or other
debris, the indicators for "2" and "3" start blinking and
the tool automatically stops.
In this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
NOTICE:
Depending on the usage conditions,
the tool is automatically turned off without any
indication if the tool is overloaded by entangled
branches or debris. In this case, switch off the
tool and remove the battery cartridge, and then
remove entangled branches or debris using tools
such as pliers. After removing the branches or
debris, install the battery cartridge and turn on
the tool again.
Overheat protection for tool or
battery
There are two types of overheating; tool overheating
and battery overheating. When the tool overheating
occurs, all speed indicators blink. When the battery
overheating occurs, indicator for "1" blinks.
If the overheating occurs, the tool stops automatically.
Let the tool and/or battery cool down before turning the
tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically and indicator for "1" blinks.
If the tool does not operate even when the switches are
operated, remove the battery from the tool and charge
the battery.
Power switch action
WARNING:
For your safety, this tool is equipped
with lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you sim-
ply pull the switch trigger without pressing the lever.
Return the tool to our authorized service center for
proper repairs BEFORE further usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of lever.
WARNING:
Before installing the battery car-
tridge on the tool, always check to see that the
switch trigger and lever actuate properly and return
to the "OFF" position when released.
Operating a
tool with a switch that does not actuate properly can
lead to loss of control and serious personal injury.
CAUTION:
Never put your finger on the switch when
carrying.
The tool may start unintentionally and cause injury.
NOTICE:
Do not pull the switch trigger hard without
pressing the lever. This can cause switch breakage.
Press the main power button to turn on the tool. The
power lamp lights up when the tool is turned on. To turn
off the tool, press and hold the main power button. The
power lamp goes off when the tool is turned off.
1
2
►
1.
Power lamp
2.
Main power button
NOTE:
The tool is automatically turned off if the tool is
not operated for a certain period.
To prevent the switch trigger from being accidentally pulled,
a lever is provided. To start the tool, pull the switch trigger
while pressing the lever. Release the switch trigger to stop.
1
2
►
1.
Lever
2.
Switch trigger