Makita DHR280, Инструкция по эксплуатации

Страница: 27 / 186

27 ENGLISH
The tool and vacuum cleaner are away
from each other (out of the transmission
range). Get the tool and vacuum cleaner closer to each
other. The maximum transmission distance is
approximately 10 m however it may vary according
to the circumstances.
Before finishing the tool registration/
cancellation;
- the switch trigger on the tool is pulled
or; - the power button on the vacuum
cleaner is turned on.
Push the wireless activation button briefly and
perform the tool registration/cancellation procedures
again.
The tool registration procedures for the
tool or vacuum cleaner has not finished. Perform the tool registration procedures for both the
tool and the vacuum cleaner at the same timing.
Radio disturbance by other appliances
which generate high-intensity radio
waves. Keep the tool and vacuum cleaner away from the
appliances such as Wi-Fi devices and microwave
ovens.
The vacuum cleaner does not run
along with the switch operation of the
tool. The wireless unit is not installed into the
tool. The wireless unit is improperly
installed into the tool. Install the wireless unit correctly.
The terminal of the wireless unit and/or
the slot is dirty. Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
The wireless activation button on the
tool has not been pushed. Push the wireless activation button briefly and make
sure that the wireless activation lamp is blinking in
blue.
The stand-by switch on the vacuum
cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to
"AUTO".
More than 10 tools are registered to the
vacuum cleaner. Perform the tool registration again.
If more than 10 tools are registered to the vacuum
cleaner, the tool registered earliest will be cancelled
automatically.
The vacuum cleaner erased all tool
registrations. Perform the tool registration again.
No power supply Supply the power to the tool and the vacuum
cleaner.
The tool and vacuum cleaner are away
from each other (out of the transmission
range). Get the tool and vacuum cleaner closer each other.
The maximum transmission distance is
approximately 10 m however it may vary according
to the circumstances.
Radio disturbance by other appliances
which generate high-intensity radio
waves. Keep the tool and vacuum cleaner away from the
appliances such as Wi-Fi devices and microwave
ovens.
The vacuum cleaner runs while the
tool's switch trigger is not pulled. Other users are using the wireless
activation of the vacuum cleaner with
their tools. Turn off the wireless activation button of the other
tools or cancel the tool registration of the other tools.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing filter of dust case
Optional accessory
1. Remove the dust case while pressing
down the lever of the dust case. ►
Fig.53: 1.
Lever
2. Insert the flat-blade screwdriver into the
slots of the filter cover to remove the filter cover. ►
Fig.54: 1. Flat-blade screwdriver 2. Filter cover