Makita DHR280, Инструкция по эксплуатации

Страница: 26 / 186

26 ENGLISH
Others Red 3 seconds The power is supplied to the wireless unit and the wireless
activation function is starting up.
Off - - The wireless activation of the vacuum cleaner is stopped.
If the cancellation is performed successfully, the wireless activation lamps will light up in red for 2 seconds and start
blinking in blue.
Perform the following procedure when cancelling the tool
registration for the vacuum cleaner.
1. Install the batteries to the vacuum cleaner and
the tool.
2. Set the stand-by switch on the vacuum cleaner
to "AUTO".
►
Fig.51: 1. Stand-by switch
3. Press the wireless activation button on the vacuum cleaner for 6 seconds. The wireless activation lamp
blinks in green and then become red. After that, press the wireless activation button on the tool in the same way.
►
Fig.52: 1. Wireless activation button 2. Wireless
activation lamp
Troubleshooting for wireless activation function
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality Probable cause (malfunction) Remedy
The wireless activation lamp does not
light/blink. The wireless unit is not installed into the
tool. The wireless unit is improperly
installed into the tool. Install the wireless unit correctly.
The terminal of the wireless unit and/or
the slot is dirty. Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
The wireless activation button on the
tool has not been pushed. Push the wireless activation button on the tool
briefly.
The stand-by switch on the vacuum
cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to
"AUTO".
No power supply Supply the power to the tool and the vacuum
cleaner.
Cannot finish tool registration /
cancelling tool registration
successfully. The wireless unit is not installed into the
tool. The wireless unit is improperly
installed into the tool. Install the wireless unit correctly.
The terminal of the wireless unit and/or
the slot is dirty. Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
The stand-by switch on the vacuum
cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to
"AUTO".
No power supply Supply the power to the tool and the vacuum
cleaner.
Incorrect operation Push the wireless activation button briefly and
perform the tool registration/cancellation procedures
again.
Cancelling tool registration for the
vacuum cleaner
NOTE: The wireless activation lamps finish blinking in
red after 20 seconds elapsed. Press the wireless
activation button on the tool while the wireless
activation lamp on the cleaner is blinking. If the
wireless activation lamp does not blink in red, push
the wireless activation button briefly and hold it down
again.