Makita DF033D, Инструкция по эксплуатации

Страница: 12 / 81

12 ENGLISH
Drilling in metal
To prevent the drill bit
from slipping when starting a
hole, make an indentation with a center-punch and
hammer
at the point to
be drilled. Place the point
of the drill bit in
the indentation and start drilling.
Use a cutting lubricant when
drilling metals. The exceptions are
iron and brass which should
be drilled dry.
CAUTION:
Pressing excessively on the tool
will not speed up the drilling. In fact, this excessive
pressure will only serve to
damage the tip of
your drill bit,
decrease the tool
performance and shorten
the service life of the tool.
CAUTION:
Hold the tool firmly and exert care
when the drill bit begins to break through the
workpiece.
There is a tremendous force exerted on
the tool/drill bit at the
time of hole break
through.
CAUTION:
A stuck drill bit can be removed
simply by setting the reversing switch to reverse
rotation in order to back out. However, the tool
may back out abruptly if you do not hold it firmly.
CAUTION:
Always secure workpieces in a vise
or similar hold-down device.
CAUTION:
If the tool is operated continuously
until the battery cartridge has discharged, allow
the tool to rest for 15 minutes before proceeding
with a fresh battery.
Using the tool as a hand
screwdriver
►
Fig.14
Switch off the tool.
Move the reversing switch lever to the neutral position.
Turn the adjusting ring so
that the arrow points to
the marking.
Turn the tool.
NOTE: This use is convenient for checking the
screwdriving.
NOTE: Do not use the tool for work requiring
excessive force, such as
tightening bolt or
removing rusted screws.
Using holster
Optional accessory
CAUTION:
When using the holster, remove a
driver bit/drill bit from the tool.
CAUTION:
Turn off the tool and wait until it
comes to a complete stop before placing it in the
holster. Be sure to close the holster securely with
the holster button so that it holds the tool firmly.
1. Thread a waist belt
or similar through holster
holder. ►
Fig.15: 1. Holster holder 2.
Waist belt
2. Put the tool in
the holster and lock
it with the holster
button.
►
Fig.16
►
Fig.17
You can keep two driver
bits at the front of
the holster.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and
RELIABILITY, repairs, any other
maintenance or adjustment should
be performed by Makita
Authorized or Factory Service
Centers, always using Makita
replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual.
The use
of any other
accessories or attachments might present
a risk of injury to persons. Only
use accessory or
attachment for its stated purpose.