Makita DCS 9010, Инструкция по эксплуатации

Страница: 21 / 28

21
Cleaning the air Þ lter
- Demount the Þ lter cover ( A/1 ) (2 screws).
Caution : Pull the choke ( A/2 ) to shut the choke shutter and
to prevent dirt particles from entering the carburetor.
- Loosen the two screws ( A/4 ) and remove the air Þ lter ( A/3 )
from the intake stack.
- Position a screw driver between the two latches and separate
the upper and lower part by turning it.
- Clean the air Þ lter with a soft brush.
- If the Þ lter is very dirty, clean it in lukewarm soapsuds with
standard detergent.
- Let the air Þ lter dry completely .
- Assemble the upper and lower part and put them on the
intake stack. Firmly tighten the screws ( A/4 ).
If the Þ lter is very dirty, clean it frequently (several times a day),
because only a clean air Þ lter guarantees full engine power.
CAUTION:
Replace damaged air Þ lters immediately.
Torn off pieces of cloth may destruct the engine.
Replacing the spark plug
CAUTION:
Do not touch the spark plug or plug cap if the engine is
running
(high voltage) .
Switch off the engine before starting any maintenance
work.
A hot engine can cause burns. Wear protective gloves!
The spark plug must be replaced in case of a damage of the
insulating body, consumption of the electrodes or if the elctrodes
are very dirty or oily.
- Loosen both screws of the Þ lter cover ( A/1 ) and remove
the Þ lter cover (see Þ g. clean air Þ lter).
- Pull off the plug cap ( C/3 ) from the spark plug. Only use
the universal wrench delivered with the chain saw for de-
mounting.
- Mount the new spark plug in the reverse order.
CAUTION: Use only the following spark plugs:
NGK BPMR 7A or BOSCH WSR 6F .
Electrode gap
The electrode gap must be 0.5 - 0.8 mm.
Checking the ignition spark
- Press the loosened spark plug with the Þ rmly connected
ignition cable against the cylinder by means of insulated
pliers (not near the spark plug opening).
- ON/OFF switch in START position "I".
- Start the engine by forcefully pulling out the starter cable.
If the function is correct, an ignition spark must be visible near
the electrodes.
B
0,5 - 0,8 mm
C D
3
A
2
3
4
1