20
Replacing the return spring
Replacing the suction head
- Demount the fan housing (
J/1
).
- Loosen the screw with the star-shaped recess (
J/2
) on the
pivot.
- Pull off the pivot (
J/3
).
- Remove the cable drum (
J/4
).
- Demount the spring cover (
J/5
) (3 screws).
- Slightly knock the hollow side of the fan housing on wood
while holding it tightly. Thus the old spring will jump out and
release.
- The new spring is delivered in a box, under full tension.
For mounting the whole box is pressed into the fan housing
and the wire ring is stripped off (a spring which has jumped
out is remounted by turning it clockwise into the housing).
- Pull the suction head by means of a bent wire through the
tank opening.
- The
felt
Þ
lter (
K/1
) of the suction head can be clogged.
- It is recommended to replace the suction head once every
three months in order to guarantee an unimpeded fuel
ß
ow to the carburetor.
- Demount the fan housing (
H/1
) (4 screws).
- The cable drum must not be demounted.
- Remove the old cable.
-
Mount the new cable (ø 4x1000 mm) and tie it up in a
simple
knot in the drum, and in a knot
with a loop
in the starter
grip. The end of the cable must not project the drum.
- Wind the cable around the drum as far as possible. Then
pull the cable with the starter grip approx. 50 cm out of the
drum, hold the drum tightly and wind the cable once again
around the drum.
- Release the drum and let the cable wind up by means of
the spring tension. The starter grip must now stand upright
at the outside of the starter casing.
NOTE:
When the starter cable has been completely pulled out, it
must be possible to turn the cable drum against the spring
tension through 1/4 rotation.
I
Replacing the starter cable
J
K
3
1
2
4
5
1
H
1
Содержание DCS 9010
Страница 27: ...27 Notes...
