![background image](http://html.mh-extra.com/html/makita/cru03/cru03_instruction-manual_232709013.webp)
13 ENGLISH
3.
Wear the shoulder harness of the portable power
pack and lock the buckle on the waist belt.
4.
Insert the plug of the tool into the socket of the
portable power pack.
When inserting, align the triangle marking on both the
plug and the socket.
1
2
3
►
1.
Plug
2.
Socket
3.
Triangle marking
5.
Tap the main power button to turn on the tool.
The tool is ready to operate. The tool will run when you
pull the switch trigger.
1
►
1.
Main power button
CAUTION:
When suspending the operation, always
turn off the tool and remove the plug from the socket.
Failure
to do so may cause personal injury due to unintentional start up.
When quitting the operation, press and hold the main
power button until the speed indicator goes off and then
perform the above procedure in reverse.
Correct handling of the tool
WARNING:
Always position the tool on your
right-hand side.
Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury.
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity.
Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
WARNING:
To avoid accident, leave more
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
Correct positioning and handling allow optimum control
and reduce the risk of injury.
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
1
►
1.
Most effective cutting area
Содержание CRU03
Страница 15: ...15 ENGLISH 95 M10L 3 m 9 ft 80 mm 3 1 8 100 mm 3 15 16 ...
Страница 16: ...16 ENGLISH B F ECO 4L 3 m 9 ft 80 mm 3 1 8 100 mm 3 15 16 ...
Страница 33: ...33 ESPAÑOL 95 M10L 3 m 9 ft 80 mm 3 1 8 100 mm 3 15 16 ...
Страница 34: ...34 ESPAÑOL B F ECO 4L 3 m 9 ft 80 mm 3 1 8 100 mm 3 15 16 ...