Makerfarm Pegasus 12, Инструкция по эксплуатации, Страница: 57 / 80

57
Next get the glass and hairspray mentioned on page 4 of the build guide, if
you haven’t already broken the corners off to clear the bolt heads you can
do that now. I use plers to break a small amount of glass in each corner
and repeat until the glass will sit flat on the heat bed and not on top of the
bolts in each corner (The heat bed will not be flat which is why you have
glass as a flat print surface). Once the glass fits in between the bolt heads
spray one side of the glass with the hairspray, usually this should take
about 5 seconds to cover the whole glass with the right amount of
hairspray. (Usually I spray the glass once a month then every 4-6 months
I remove the glass and wash all the hairspray off under hot water). Last
use the binder clips to hold the glass to the heat bed (I remove the binder
clip legs as they can vibrate or hit the electronics, keep the legs for when
you need to put the glass back on the printer)