Makerfarm Pegasus 12, Инструкция по эксплуатации, Страница: 42 / 80

42
Next get your
belt and cut a
piece off that is
39 inches long
loop one end
over and use a
zip tie to secure
it, then install
the belt through
the Idler
bearings.
Install the loop
onto the
wooden mount
using an
M3x25mm bolt
and Nylon lock
nut, then run
the belt back to
the motor,
around the GT2 Gear then back to the wooden mount, Loop the other end making
sure that the belt will be tight when you install it into the wooden mount, then zip tie
the loop and install the loop to the wooden mount using the other M3 bolt and Nylon
Lock nut.
If you need to adjust the tension of the belt you can adjust the Y belt bearings in the
front of the machine by moving them as far to the front of the machine as possible
then tightening the
M5x30mm bolt back
down.