Make Noise Rene, Руководство пользователя

Страница: 9 / 19

Controls
4x4 CV Programming grid: Potentiometers sets Tuned Voltage for corresponding Locations, 0 thru 15.
4x4 touch grid: In PLAY mode, the touch pads may be used to set ACCESS in real time, effectively allowing
the performer to play the ACCESS parameter. In use, this means that René will go to only the locations that
the performer is touching. Additionally, touching and releasing a single location while René is PLAYing will
set a new start point, thus creating a variation on your sequence. With no Clocks patched to René, touching
any location on the Touch Grid will select said location, and the CV and QCV value is held until the next
location is touched, or a clock pulse is applied to either X-CLK or Y-CLK. This is useful for Programming or
Tuning Notes (with CV applied to VCO 1V/oct input, for example). In ProGraM Pages, the Touch Grid is used
select and deselect the various parameters available under each PGM Page.
PGM 1: This Touch Plate is used to cycle through the different ProGraM Pages. Each of the 6 ProGraM pages
has an associated LED which lights when selected. PGM1 returns to last selected PGM Page.
PGM 2: While PLAYing, this Touch Plate is used to Latch/Unlatch the steps held by the performer using the
4x4 Touch Grid. Once within the PGM Pages, the PGM2 touch is used to EXIT the PGM Pages and return to
PLAY. The PGM2 button is also used to save the default start‐up programming for René. To do this, make all
changes to all ProGraM Pages. Touch PGM2 and exit PGM Pages. Now, Touch and [HOLD] PGM2 until all
PGM LED’s blink.
Play
This is the primary state of mind in which René will exist. The Location Lights (within the Knobs) show the
Cartesian or Snake motion of the sequence through the grid. While in PLAY, the performer may usethe
touch grid to ProGraM ACCESS on the fly, stop and hold the sequence at a particular note or set a new start
point. Touching PGM1 brings up the PGM Pages (see below). Touching PGM2 LATCHES locations currently
touched by the performer (if any). All of the PGM Page LEDs will light until PGM2 is touched again, at which
point the Latched pattern is no longer. Movement is always governed by the X-CLK and Y-CLK inputs. For
example, the performer cannot select a three step sequence in the Y direction if there is no Y clock signal
input. Touch and HOLD PGM2 for 2 seconds, and the current state of René (all programming) is saved as the
start‐up state.