Make Noise Rene, Руководство пользователя

Страница: 13 / 19

A
LOC. 10
B
LOC. 11
B
LOC. 4
E
LOC. 5
F
LOC. 6
G
LOC. 7
G
LOC. 3
E
LOC. 2
D
LOC. 1
D
LOC. 0
C
LOC. 9
A
LOC. 8
I
II
III IV
LOC. 14 LOC. 15 LOC. 13 LOC. 12
ACCESSES STORED QUANTIZED
VOLTAGES, SQV
APPENDIX B
Stored Quantized Voltages
While at the Quantize Page, to store all 16 Voltages as set by the potentiometers and the ProGraMmed Scale
as set by touch grid Locations 0 thru 11, touch and hold either Location 12, 13, 14, or 15 until all 6 PGM LEDs
flash. When Locations 12, 13, 14, or 15 is ON while accessing the Q Page, the QCV Out will produce voltages
per location as well as the scale in which they were initially stored. The scale may still be edited on the fly,
but the knobs will no longer be “live” while any one of the Stored Quantized Voltage (SQV) sets is in use. To
turn OFF the Stored Quantized Voltages set, touch the location of the active set, thus toggling the SQV to
OFF.
With the scale AND the Voltages you have programmed stored, you effectively have two channels of Control
Voltages. The most common use would be to apply the QCV to 1V/ Octave input on your VCO, Program
your scale and the notes you want to use in your composition. Store those to one of the 4 locations (12, 13,
14, 15). If you want variations, then store those variations to the remaining locations. Now, patch the CV
out (un‐Quantized) to a timbre control, such as FM Index, wave shape, or filter resonance. Because your
QCV is using the Stored Quantized Voltages to drive the VCO, the un-Quantized CV out is now independent,
as you are able to turn the knobs to program new voltages to controltimbre without changing the notes
pattern driving your VCO. Apply the Gate outs to EG/ VCA combo or Low Pass Gate, and you have full
control of one voice.
TURN ON/OFF VALUES
TO ADJUST ACTIVE SCALE