26
Kleiss MCS60-38 System Manual v.15 May 2020
|
www.MainlineControlSystems.com
Pull stopper up into tower.
Lock the stopper rod by operating the orange
handle.
Grease stopper rod with silicone grease.
Operate the gear handle and crank gear box to
lowest position.
Select the proper chute from the sizing table in
Section 4.0.
NOTE: Locate the cute identification number
(stamped 1 or 2) on the bottom of the chute.
Connect the chute into the bottom of the stopping
tower.
(There is only one way to connect the chute
properly and that is to match the pin and hole. The
chute fits the tower properly if a “click” is heard
after insertion.)
Using the same Kleiss silicone spray you used
on the stopper, lightly spray the open end of the
chute.
