Maico MB 11 BERAphone, Руководство по эксплуатации

Страница: 20 / 85

Operation Manual MB 11 BERAphone
®
/Classic
8100496 Rev. 6 18 23/10/2019
Accessories/Replacement Parts
3.3.5.1 General
Some reusable components are subject to wear with use over time. We recommend
that you keep theses replacement parts available (as appropriate for your MB 11
device configuration).
3.3.5.2 Replacement of Stainless-steel Electrodes (MB 11 BERAphone
®
Only)
Replacement of the removable electrodes is recommended at least every 3 months. More
frequent replacement of electrodes may be required based on the cleaning and
maintenance practices of the facility. Replacement electrodes are available from MAICO.
1. Remove the electrode tip/gel protector assemblies from the fixed electrode
posts by pulling each one straight out from the fixed post.
2. Discard the old electrodes.
3. Connect a new set of electrodes to the posts by aligning them with the spring-
loaded pin and pressing them fully onto the pin.
3.3.5.3 Replacement of Ear Cushions (MB 11 BERAphone
®
Only)
Replace the ear cushion with a new one as needed. Replacement of the ear cushion
is recommended at least every 3 months. More frequent replacement of the ear
cushion will be required if the facility uses an alcohol based disinfectant product.
Replacement cushions are available from MAICO or your local distributor.
1. Remove the ear cushion by pulling it off the BERAphone
®
.
2. If there is any debris on the plastic mounting for the ear cushion, clean and disinfect
the area using a disinfectant wipe and allow the disinfectant to dry thoroughly.
3. Attach a new ear cushion to the BERAphone
®
.
a. A small notch at the top of the plastic mounting for the ear cushion
can be used to start the connection of the ear cushion followed by a
counter-clock-wise rotation of the ear cushion until it is fully attached
to the plastic mounting.
b.
The ear cushion can also be attached by stretching it around the
plastic mounting until it is fully seated in place.