4.3 Electrical Installation
Prior to plugging in observe the following safety instructions:
Protect your device with separate pre-fuses (not
included in the scope of delivery) according to
the information provided under point 2 „Techni-
cal Data“
Make sure that the pre-fuse is not overloaded
by other devices (e.g. fan heaters, deep freezers,
etc)
Check whether the main voltage and frequency
correspond to the information on the rating
plate underneath the grinder.
Insert the plug into the corresponding grounded outlet.
4.4 Adjustment of the port-a-fi lter rests
The grinder is designed so that all different port-a-fi lters from vari-
ous espresso machines fi t into the rest for hands-free grinding op-
eration.
4.4.1 Keep the grinder switched off. Slightly loosen the allen screws
(pos. 13) with the included allen screw driver size 3mm and pull
down the port-a-fi lter rest (pos. 12).
4.4.2 Push the port-a-fi lter of your espresso machine onto the start/
stop switch between the port-a-fi lter mounting (pos. 11) and the
rest (pos 12). Now push up the port-a-fi lter rest until the port-a-
fi lter holds on its own. Now refasten the screws.
4. Set-up and Initial Adjustments
You have received your grinder in operating condition. Now you only
need to place it in a safe place and connect it to the main power
socket. Proceed as follows:
4.1 Place of Installation
Place the grinder on a level, vibration-free surface.
Never operate the grinder in moist, or even
worse, in wet surroundings!
4.2 Locking in the hoppers
Set the hopper into the bayonet socket. Grab the hopper with both
hands and turn it carefully in clockwise direction, until the bayonet
locks in.
Always loosen the grind adjustment brakes and
turn both adjustments to fi ne (setting 0) when
locking in the hoppers. Turning the grind adjust-
ment ring repeatedly without loosening the
brake could damage the interlock.
Fasten the lock screw for the hopper (pos. 2) to prevent the hoppers
from unauthorized removal.
|
H O R E C A
G A S T R O G R I N D E R
