7
ASSEMBLY
STEP 1
SNOWBLOWER PREPARATION
Place the chute (item 1) (opening facing forward) over
the rotation ring as illustrated.
Make sure the rotation ring (item A) is positioned as
shown.
Secure in place with five 1/4 x 1 1/2’’ bolts (item 2)
and five 1/4’’ nylon insert lock nuts (item 3). Do not
tighten too tightly.
(Nuts that are too tight could prevent the chute from
turning from one side to the other. A slight pressure is
enough.)
If needed, adjust the hydraulic motor (item 3) to make
sure the grooves are well inserted into the ones of the
rotation ring. Start by removing the the guard (item 1).
Then loosen the three nuts on the carriage bolts (item
4) that hold the hydraulic motor in place. Do not
remove the nuts.
Slide the motor towards the chute (item 5) as shown
(the grooves on the motor’s sprocket must be inserted
into those of the rotation ring). Adjust and retighten
the nuts. Tighten firmly.
Reinstall the sprocket guard (item 1) as shown and
secure in place with two 1/4’’ x 1/2’’ bolts (item 2).
Install the chute
Install the sprocket guard
WARNING
Operate only when all the guards are in place.
