9
ASSEMBLY
PTO drive shaft installation
Install the PTO driveshaft (item 1) on the snowblower
input shaft (item 2). Then install the two bolts M12 x
1.25 x 70 Grade 8.8 (item 3) and nuts
PTO drive shaft chain installation
Install the PTO driveshaft chain (item 4) on the
accessory.
WARNING
Operate only when all the guards are in place.
STEP 4
INSTALLATION ON THE TRACTOR
A) With the standard 3 points hitch:
The sleeves (items 3 & 4) can be discarded from the
hardware bag.
Temporarily remove hitch pins and the hair pins 4mm
(item 1 ) and the sleeves for the category 2 (item 5).
The
lower arms of the 3 point hitch
must be
stabilized to prevent side
-
to
-
side movement. Most
tractors have sway blocks or adjustable chains for this
purpose. (Please consult your tractor’s manual for
adjusting instructions).
Place the accessory
on a flat level surface.
Slowly back the tractor up to
the accessory while
using the tractor’s 3
-
point hydraulic control to align the
holes in lower 3
-
point arms with the holes for hitch
pins “A”. .
For the category 1 hitch, place the arms in the B1
location. For the category 2 hitch put the sleeve (item
5) over the hitch pin.
Connect the 3 point hitch’s
upper central link
with the
hitch pin et with the hair pin 4mm (item 2)
WARNING
Always engage parking brake, shut tractor engine off
and remove key before dismounting from tractor.
Figure G: Installation on tractor
