20
BA060801-en
The upper left part of the display shows in what range the RPM is:
•
If the flashing square is within the limits, the RPM is within
the tolerance corridor.
>
<
0.0 Nm
0.0 kW
0 min
-1
•
If the square is located to the left of the limit, the RPM is
too low. The vehicle cannot approach the next target RPM.
Cancel the test with <ESC>. This case may occur if an
exaggerated target RPM was entered, e.g. tractor has
U
max
= 1050
min
-1
, and U
tar
= 1200 min
-1
was entered.
> <
0.0 Nm
0.0 kW
0 min
-1
•
If the square is located to the right of the limit, the RPM is
too high. In this case, the dynamometer can no longer
regulate the RPM, because the performance range of the
brakes is exceeded. This message appears: "Error Brake 1
100% performance".
>
<
0.0 Nm
0.0 kW
0 U min
-1
A printout is automatically created with a discrete measure-
ment. After the discrete measurement has been completed, the
program returns automatically to the measurement display of
the main menu. There, using <F3>, a different measurement
method can be selected or a new menu opened once the
power take-off shaft has come to a standstill.
0.0 Nm
→
0.0 kW
0 min
-1
In the event of overload the measurement value "
−
−
" is shown.
After measurement, continue driving the power take-off shaft without load to cool down the
brake.
Pos : 72 /-----Format-----/MANUELLER UMBRUCH Seit enumbr uc h @ 0\ mod_1134403577687_0. doc x @ 1277 @ @ 1
