Español Italiano Nederlands Français
English
Deutsch
14
Disc brake service kit (code: 0721 294)
Don’t panic if the hose snaps! With the disc brake service kit and a separately available
spare hose (see spare parts pages 21/22), this can be repaired easily.
The Marta is a high-pressure system and comes with a reinforced hose, the
„MAGURA Disc Tube“ wearing also this imprint. The Disc Tube needs an additional
insert for a proper fitting. Never mix and match either the hoses or other parts from
the other MAGURA disc brake models! Any misuse might cause serious accidents!
1.
Remove the damaged hose from both the brake lever and the caliper. Cut off the
barbed adapter (caliper connection) with a sharp knife. Slide both the sleeve nut and hose
protector on the other side. All mentioned parts can be re-used. Throw away the damaged
hose.
2. Prepare a new hose:
Use only the reinforced „MAGURA Disc Tube“ hose!
One end this hose comes with a pressed fitting, which has to be screwed into the caliper as
described above.
Tightening torque: 6 Nm/ 51 in.lbs.
Never shorten this hose at the end with the pressed fitting! You could no longer
use the hose then.
3.
Tighten the prepared end of the new hose onto the caliper.
Tightening torque: 6 Nm/ 51 in.lbs.
4.
Mount the brake hose as described in chapter 6.
After the installation of a new hose you will always have to refill the brake. The
following chapter 9 describes how the filling has to be done.
5.
The new Marta is also compatible with the 90° hose fitting. Mounting as shown, also
see page 20.
8. Repairs
