THE PASSION PEOPLE
www.magura.com
11
Hold the hose carefully so that it cannot snap away (arrow)! Cut the hose squa-
rely! The sleeve nut can be re-used. The olive and the insert cannot be
reused and must be replaced!
5.
Press manually a
new
insert into the hose until it is
fully seated.
Clamp the hose
into the groove of the mounting device as shown...
6.
...or clamp the mounting device as shown into a vice and hammer the insert
careful-
ly
into the hose.
7.
Slide on the sleeve nut and a
new
olive onto the hose. Push the hose with the sleeve
nut and the new olive
fully
into the brake lever and tighten the sleeve nut with
an 8mm open-end wrench.
Tightening torque: 4 Nm/ 34 in.lbs.
8.
Always check for correct installation by pulling on the hose. Make sure that
the system has no leaks. Squeeze the lever blade, hold pressure and check hose con-
nections and the reservoir cover for eventual leaks.
Squeeze the lever blade several times (pump) to push the pads to their proper
position until the lever feel becomes very firm. If you cannot realize this, bleed the
brake (see page 15 onwards).
