MAGUIRE Ultra-600, Установка, эксплуатация и обслуживание

Страница: 59 / 109

Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
59
ULTRA By Maguire

- Ultra Low Energy Dryer
Loadcell Calibration
Zero Weight Calibration
BE SURE The Air supply is on.
BE SURE The Vacuum Chamber and Retention Hopper is EMPTY.
BE SURE The Vacuum Chamber and Retention Hopper are hanging / resting freely on the load cells.
BE SURE The air lines are connected.
LOAD CELL ZERO CALIBRATION
The sequence is as follows:
Press
Display will prompt for a password. (default: 22222) Then press:
Press
Dryer Configuration
Display will show menu options
Press Load-Cell Setup
Display will show Load-Cell Calibration Screen
Press Vacuum Chamber
Zero/Full Calibration
Display will show the ZERO / FULL Calibration screen.
Press
ZERO
Display will say: Confirm Vacuum Chamber is empty then
press ZERO. Gram weight of
0 follows successful
calibration.
Press
To return to the Load-Cell Setup screen.
Press Retention Hopper
Zero/Full Calibration
Display will show the ZERO / FULL Calibration screen.
Press
ZERO
Display will say: Confirm Retention Hopper is empty then
press ZERO. Gram weight of
0 follows successful
calibration.
Press To return to the Load-Cell Setup screen.
Press To return to the Main Screen.
The ZERO point of the load cells is now set properly. FULL weight calibration may also be
done at this time; however, it probably is NOT NECESSARY. When load cell readings shift
due to rough handling, the entire range of readings from ZERO to FULL shift together. The
ZERO weight calibration routine resets the full range of the cells and, therefore, corrects FULL
weight readings as well.