MAGUIRE Ultra-600, Установка, эксплуатация и обслуживание

Страница: 20 / 109

Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
20
ULTRA By Maguire

- Ultra Low Energy Dryer
Important Settings
4. Operating the Controller (Home Screen):
Bulk Density
– Bulk density is the weight per unit
volume of the raw plastic material as it is received from
the material manufacturer. This parameter is important
to set to ensure proper performance of the ULTRA-600.
Bulk density can be edited under ‘Advanced Info’.
***WARNING:
Without setting this parameter the machine may
not maximize its material throughput and/or have a chance to
overflow.
T1 Inlet Temp Setpoint
– This is heat hopper inlet
temperature. By the end of the preheat cycle time, all
material in the Heating Hopper will be heated to this
temperature. By default, the Setpoint temperature is set
to 150°F. Contact the material manufacturer for
temperature recommendations.
Preheat Time
– This is the duration of heating from a
cold start.
Vacuum Time
– This is the duration of a vacuum and is
what determines the cycle time. The default vacuum
time is 20 minutes. In the vast majority of drying
operations, this time is adequate and does not need to
be adjusted. Special circumstances may require
different vacuum times. Please consult a Maguire Dryer
Technical for additional information.
Press the setpoint field to adjust the setting. Use the on-
screen keypad to enter the setpoint and press the green
check to complete the setting adjustment
.
Material Outflow Valve
– Ensure that this valve on the
bottom of the retention hopper is OPEN . This will allow
the processed material to leave the machine.
Failure to OPEN this valve will halt the drying process.
To check the state of the valve, press the retention
hopper icon on the home screen.
The button displays the current state. Press the
CLOSED button so it reads OPENED. The valve will
now remain open.
Press the START button to start the dryer
→