MAGUIRE FLEXBUS Lite, Установка, эксплуатация и обслуживание

Страница: 58 / 143

58
BER - Grams over weight to abort a component dispense.
This parameter prevents over filling the weigh bin.
A component dispense aborts when weight exceeds target by BER value.
Remaining components dispense normally.
1 in the last position (00201), causes USB printout of cycle data when abort occurs.
Typically, no change is required.
If vibration causes false abort, then set a higher value.
Default is 00200 (20 grams or 200 grams model dependent).
Micro Blender (MB), 100, 200 Series - 10ths of grams
400, 900, 1800, 2400, 3000 Series – grams
ROC 00000
REGRIND OVERCOLOR - ROC, ROV, and RHL help control regrind usage.
ROC indicates the PERCENT of REGRIND that will be treated as natural when
COLOR and ADDITIVE dispenses are calculated. This adds some color or additive
to your regrind.
ROV 00000 REGRIND OVERRIDE - ROV is for closed loop fully automatic reprocessing of
regrind scrap. This parameter will detect when more regrind is being produced than
consumed, and override the current setting to use a higher amount. This helps
prevent material backing up in your grinder.
RHL 00000 REGRIND LEVELS – HI/LOW - RHL has effect only if level sensors are added to
your unit to detect material level in the regrind hopper. These level sensors can alter
regrind percent usage.
MIX 00015
Mix Time (Seconds)
TIME mixer motor runs after weigh bin dumps.
JOG 03030 Mixer operation after MIX time (count/seconds)
After MIX time, JOG will operate mixer 1 turn, every xx seconds for a total count of
xxx times. First 3 digits
000 00 is the total count. Last two digits 000 00 is the interval
in seconds.
MPO 00000 Micro Blender Mix Time
For Micro Blender air driven reciprocating mixer
MPO sets the timing, in tenths of seconds the clockwise and counterclockwise timing
of the mix blade. MPO 00010 is 1 second for each direction.
FCV 00006 Flow Control Valve - Delays opening and closing of the flow control valve
Digit 1 = When Power Off: 0 = CLOSED (default), 1 = OPEN
(must reverse air lines).
Digits 2 and 3 = time delay in seconds before closing.
Digits 4 and 5 = time delay in seconds before opening.