Magtek MICRSafe, Техническое справочное руководство

Страница: 27 / 79

Section 4. Legacy Commands
19
DM – DISABLE MICR COMMAND
This command disables the document reading function and turns off the LED.
Communications are not affected. The motor will not turn on when a document is
inserted. To execute, send the DM command followed by a carriage return as follows:
DM<CR>
EM – ENABLE MICR COMMAND
This command enables the document reading function, and the LED will turn green. To
execute, send the EM command followed by a carriage return as follows:
EM<CR>
KS – ENABLE KEYSTROKE COMMAND
This command determines if the MICRSafe will send responses to the host via the USB
interrupt pipe or as Keystrokes (that will appear to the host application as if typed on a
keyboard). To execute, send the KS command followed by a carriage return as follows:
KS00<CR>
(to send responses to the host via the USB interrupt pipe)
or
KS01<CR>
(to send responses as keystrokes)
SLP – SLEEP MODE COMMAND
This command puts the MICRSafe into sleep mode for the specified time interval. While
in sleep mode, the green LED dims to half brightness. To execute, send the SLP
command followed by a carriage return as follows:
SLPB4<CR>
(to put the MICRSafe in sleep mode after thirty minutes of idle state)
NOTE: The two characters following “SLP” contain the Hex value of the time before the device
goes into sleep mode, with time measured in ten-second intervals. Hex FF (numeric
255) is the maximum time you can specify; 255 ten second intervals equal 42 minutes.
RD – ENABLE AUXILIARY PORT COMMAND
This command determines if the MICRSafe will send responses to the host via the
auxiliary RS-232 port. To execute, send one of the following RD commands followed by
a carriage return: