Magtek ExpressCard 2000, Процедура профилактического обслуживания

Страница: 21 / 25

3 - Preventive Maintenance Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
Page 21 of 25 ( D99875651-25 )
7) Check the daisy wheel alignment by standing in front of the device and looking straight down at the
embosser. Use an inspection mirror as shown in
Figure 3-10 so you can see the cone on the bottom
of the current character and the hole in the embosser hammer. Figure 3-11 shows a cone and hole
that are not properly aligned.
8) Check embossed character heights, and adjust them if necessary to account for normal wear. Pay
special attention to any characters you have replaced or re-mapped.
9) Note the position of the top and bottom knuckles in case they move during the following steps.
10) Add 2 drops of Teflon lubricant to the left and right sides of the shaft that holds the top embosser
knuckle, between the sides of the knuckle and the rocker arm.
11) Move the hammer follower out of the way and add 2 drops of lubricant to the top and to the front of
the top punch hammer.
12) Add 2 drops of Teflon oil to the left and right sides of the shaft that holds the bottom embosser
knuckle, between the sides of the knuckle and the rocker arm.