3 - Preventive Maintenance Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
Page 14 of 25 (
D99875651-25
)
3.7
Service the XY Transport Module
Do not lubricate the EC2000’s gears or bearings. They are made of self-lubricating powder
metal, and lubricants can damage their surfaces.
Follow these steps to lubricate the one shaft that requires lubrication.
Do not use Tri-Flow lubricant on
any shaft other than the one shown below.
1)
If there is dirt, dust, or debris on the XY transport rods, wipe it off using a soft, lint-free cloth.
2)
Use the
MCP Commands
page to move the XY transport from the front to the rear of the device to
verify the movement is smooth and there is no belt slippage. Leave the transport at the rear of the
device.
3)
Check the XY transport drive belt for any signs of damage. If it is damaged, contact MagTek Support
Services for a replacement.
4)
Stand at the front of the device and locate the XY transport shaft closest to the image printer. It is the
only shaft that has a blue bearing around it (see
Figure 3-5 - Blue Bearing On XY Transport (FRONT LEFT VIEW)
5)
Shake the bottle of Tri-Flow lubricant and remove the cap.
6)
Run a thin 3-4 inch long bead of Tri-Flow along the top of that one shaft.