Magstim BiStim²
Operating Manual
© The Magstim Company Limited
12
MOP02-EN-02
Figure 4.1: Attaching the Bistim² connecting module
7. Remove the two blanking plugs from the threaded inserts on the right-hand side of the master
unit.
8. Insert the two M6x12 hexagon bolt into the mounting holes on the coil holder. Place the coil
holder against the right-hand side of the master unit so that the bolts locate in the threaded
inserts. (See Figure 4.2) *
9. Using the supplied hexagon key tighten the bolts so as to secure the coil holder to the right-hand
side of the master unit. Do not over tighten the bolts as this may damage the cases of the units.
Figure 4.2: Attaching the coil holder
10. Connect the supplied earth strap between a functional earth connection on the master and slave
unit
*
To do this, unscrew the screw adjacent to the functional earth symbol on the rear of the master
unit using a Phillips screw driver. Place one end of the earth strap over the screw as shown in
figure 4.3 and re-attach to the unit back panel.
11. Figure 4.3: Attaching the earth strap
Repeat the above, to attach the opposite end of the earth strap to the slave unit.