Magstim BiStim²
Operating Manual
© The Magstim Company Limited
11
MOP02-EN-02
SECTION 4 OPERATING INSTRUCTIONS
Note:
to avoid problems with interference, the Magstim Bistim² system should not be used in the
vicinity of any equipment not in compliance with the EMC Standard EN 60601-1-2, including mobile
phones.
Note:
Please ensure you are familiar with all sections of this operating manual prior to following these
operating instructions.
Note:
Please consult any labelling and information accompanying stimulating coils and other
accessories for safety and use information regarding these devices.
Note:
UI functions described in this section are to be performed on the master unit UI (Bistim² UI).
Control functions/buttons are not activated on the slave unit UI (200² UI) therefore cannot be used to
control system. The only function/button that may be used is the system stop button.
4.1
Preparation
1. At the start of each session the operator must check the Magstim Bistim² system and any
accessories used for any signs of external damage and to identify any cleaning required
*
. If any
cracks are visible in the housing, or there is damage to any of the cables, the items must not be
used and should be returned to The Magstim Company Limited for servicing and repair. If
cleaning is required, please follow the instructions in Section 5 of this Operating Manual.
Note:
The contacts in the coil connector, Bistim² connecting module and the stimulator coil output
socket should be checked regularly for any signs of tarnishing or burning*. See Section 5.2 for an
example of contact burning.
4.2
Set-up
Note:
The Magstim BiStim² should be assembled following the instructions provided within this
section to ensure continued compliance of IEC 60601-1:2005.
Note:
ensure not to position the Magstim BiStim², so it is difficult to disconnect the power lead.
1. Ensure that the master and slave units of the Magstim Bistim² are switched off on the rear
*
.
2. Place the master unit on top of the slave unit ensuring the feet of the master unit fit into the
recesses on the slave unit
*
.
3. Remove the two blanking plugs from the threaded inserts on the left-hand side of the master unit.
4. Insert the two M6x60 hexagon bolt into the mounting holes on the Bistim² Connecting Module.
Place the Bistim² Connecting Module against the side of the master unit so that the bolts locate in
the threaded inserts. Ensure that the coil output socket is facing the front
*
. (See Figure 4.1)
5. Using the supplied hexagon key tighten the bolts so as to secure the Bistim² Connecting Module
to the side of the master unit*. Do not over tighten the bolts as this may damage the cases of the
units.
6. Fit the two supplied blanking inserts to the mounting holes in the Bistim² Connecting Module.
These blanking plugs are a push fit but care is needed with the positioning of the inserts to ensure
that the tops are flush with the case surface.