Magnum MLG 25, Руководство по эксплуатации и запасным частям

Страница: 24 / 52

24
ENGINE AND GENERATOR MAINTENANCE
Poorly maintained equipment can become a safety hazard! In order for the equipment to operate safely
and properly over a long period of time, periodic maintenance and occasional repairs are necessary.
NEVER perform even routine service (oil/filter changes, cleaning, etc.) unless all electrical components
are shut down. When servicing this equipment always follow the instructions listed below.
Before servicing this machine, make sure the control power switch is turned to off “O”, the circuit breakers
are open (off, “O”), the emergency stop switch is activated (pushed in), and the negative (-) terminal on
battery is disconnected. Attach a “DO NOT START” sign to the control panel. This will notify everyone that
the unit is being serviced and will reduce the chance of someone inadvertently trying to start the unit. If the
unit is connected to a remote start or transfer switch, make sure the remote switch is also off and tagged.
Never wash the unit with a high pressure hose or with any kind of power washer. Never wash the engine
block or fuel tank with a power washer or steam cleaner. Water may enter the cabinet and collect in the
generator windings or other electrical parts, causing damage. If the unit is stored outside, check for water
inside the cabinet and generator and dry the unit thoroughly before starting.
RELOADING THE TIME TO SERVICE REMINDER
After scheduled service work has been completed, it is necessary to reload the Time To Service reminder
on the controller. The timer can be reset to count down from 250 hrs. Follow the programming instruc-
tions below:
1. Press PAGE SELECT
2. Press
to select > Engine protect
3. Press ENTER
Display reads
> NextServTime
4. Press ENTER
5. Press
to scroll value to 250
6. Press ENTER
7. Press PAGE SELECT , Press PAGE SELECT again to exit
ADJUSTING DISPLAY BACK LIGHTING
While in any screen except programming:
Press and hold
ENTER while pressing to decrease contrast.
Press and hold ENTER while pressing to increase contrast.