Magnum MLG 25, Руководство по эксплуатации и запасным частям

Страница: 19 / 52

19
OPERATION STATUS
ALARM/FAULT
READY/MANUAL
RUNNING
WARNING
READY/AUTO
SUPPLYING LOAD
MAN MAN AUT L AUT L
Starting Starting
PF 1.00L
PF 1.00L
RPM 250
RPM 250
0 kW 0 0 kW 0
OPERATION STATUS
ALARM/FAULT
READY/MANUAL
RUNNING
WARNING
READY/AUTO
SUPPLYING LOAD
MAN MAN AUT L AUT L
Prestart Prestart
PF 0.00
PF 0.00
RPM 0 RPM 0
Prestart Prestart
0 kW 5 0 kW 5
9. If the engine does not start after the first cranking attempt the engine will wait for 15 seconds to allow
the starter to cool and the LCD will show “ Pause ”. The engine will make two more attempts to start for
a total of three crank cycles.
10. Should the engine not start and run the LCD display will show “ SD StartFail ”. The starting sequence
may be repeated after the starter has had a minimum of two minutes to cool. The FAULT RESET
button needs to be pressed to clear the controller. The unit will start by pressing the ENGINE START
button.
Note: the engine controller may skip the pre-heat acquisition and engine pre-heat steps.
11. Once the engine starts it will slowly begin speeding up to a constant 1800 rpm. On units with isochro-
nous engine governing, the engine may hunt or change speeds until operating temperature is reached.
After a few minutes of operation the engine will be warmed up and the LCD display will show engine
and generator operating parameters. Temperature will be shown as “
0 ” until the engine temperature is
approximately 100 degrees Fahrenheit.
Oil Press 49 psi Oil Press 49 psi
Water Temp 183°F Water Temp 183°F
Fuel Level 83% Fuel Level 83%
Batt Volts 13.4V Batt Volts 13.4V
Gen freq 60.0Hz Gen freq 60.0Hz
NomVolt (3PY) NomVolt (3PY) 208V 208V
NomAmps 300A NomAmps 300A
L1N 120V L12 208V L1N 120V L12 208V
L2N 120V L23 208V L2N 120V L23 208V
L3N 120V L31 208V L3N 120V L31 208V
G-Curr 0 0 0 A G-Curr 0 0 0 A
8. The LCD will switch from the POWER SCREEN DISPLAY to:
OPERATION STATUS
ALARM/FAULT
READY/MANUAL
RUNNING
WARNING
READY/AUTO
SUPPLYING LOAD
MAN MAN AUT L AUT L
Running Running
PF 1.00L
PF 1.00L
RPM 1800
RPM 1800
V Detect
V Detect
4 kW 15 4 kW 15
7. The Running screen will display.
NOTE: It may take a few seconds for the engine to run smoothly and reach its governed operating speed.
6. The Starting screen will display. The engine will crank and start running.
5. The Prestart screen will display (if equipped).