Automatic engine blocking
If you programmatically activate the "Automatic engine blocking" function, then the
timer of engine blocking will be started every time after turning off the ignition and open-
ing the driver's door (any door at nonseparated chains) - system's LED will flash at a rate of
4 flashes per second.
Press button
,
or
of the remote key fob or start up the ignition until the end of
the lock timer work to cancel the automatic lock.
The lock system will give short sound signal and block the engine, when the timer
expires.
Auto-Arming
If you programmatically activate the "Auto-Arming" function, then the timer of au-
tomatic arming will be started every time after turning off the ignition and opening the
driver's door (any door at nonseparated chains) - system's LED will flash at a rate of 4
flashes per second.
Press button
,
or
of the remote key fob or start up the ignition until the end of
the arming timer work to cancel the automatic arming.
When the arming timer expires, the system will give sound and light signal, closes
the central locking and will arm - LED will blink with a frequency of 1 flash per second.
Note 1:
Automatic arming of the system can be performed both with the closing of
the central door locking system, and without it - function can be programmed.
Note 2:
If the “Automatic engine blocking” and automatic arming are programmati-
cally activated, the Auto-Arming function will be started immediately after the automatic
block of the engine.
Emergency arming
If automatic arming of the system is not programmed, and use of remote key fob or
mobile phone is not possible by any reason - the system can be armed at a special proce-
dure of emergency arming:
1. Switch off ignition.
2. Open the driver's door.
3. Press and release the button of the contact sensor of driver's door 5 times within 5
seconds - the system will give short sound signal and system's LED will blink with a fre-
quency of 4 flashes per second.
4. Close the driver's door and, if necessary, open other doors or trunk (can be opened
in advance) no more than within 10 seconds.
5. Close all doors and trunk - the system will give 1 sound and 1 light signal, closes
the door locks and goes into the armed mode after 10 seconds.
M880
OPERATION MANUAL
7
Armed Mode
System will give a certain number of short sound signals at activation of the first
warning zones of sensors in the armed mode:
1 short signal
- impact sensor;
2 short signals
– tilt sensor;
3 short signals
– displacement sensor;
4 short signals
– motion sensor;
5 short signals
– additional sensor.
The system will send the corresponding voice and SMS-messages to the car owner at
discharge of the storage battery of the vehicle below the set level.
The system will send the corresponding voice and SMS-messages when you detach
and reattach a standard vehicle battery.
At activation of the second, main zones of sensors, when opening the doors, hood,
trunk, and if you turn on the ignition - the system will alarm for 30 seconds and send the
corresponding voice and SMS-messages (see "Automatic transmission of voice messages
via GSM".
Press any button on the remote key fob to switch off the alarm.
Note 1:
One second after the end or shutdown of the alarm, the system will indicate
the cause of activation by the additional sound signals:
1 long signal
– hood was opened;
2 long signals
– door was opened;
3 long signals
– trunk was opened;
4 long signals
– ignition was switched on;
5 long signals
– battery was disconnected;
1 short signal
– impact sensor was tripped;
2 short signals
– tilt sensor was tripped;
3 short signals
– displacement sensor was tripped;
4 short signals
– motion sensor was tripped;
5 short signals
– additional sensor was tripped.
Note 2:
In the case of activation of security zones of sensors, information about the
actuated sensors will be saved until disarming the system and switching on the ignition to
reset the events memory.
Note 3:
In the case if system
equipped
with the control module the GSM-channel
MCG-800, alarm messages will be sent also at loss of the periodic checking of the channel
from the module MCG-800. In its turn, the control module of the channel provides trans-
mission of alarm SMS-messages in cases when the GSM-module of the security system is:
out of range of its operator;
"busy" by any subscriber more than programmed time;
blocked by specialized "GSM-jammer";
de-energized, damaged or defective.
OPERATION MANUAL
M880
8
