Passive protection:
After turning off the ignition should be enabled any standard or
additional electrical equipment, pre-determined by the installer as "ghost button" and only
after that come out of the car. When you return to the car, if there is no potential danger or
threat from third parties, switch off the equipment, defined as "ghost" before turning the
ignition. If the ignition is turned on without switching off "ghost" - LED indicator lights up
and the program starts protection against forcible car theft.
Note 1:
Operation of "AntiHiJack from the ghost button" program and methods of its
reset are the same as described earlier in the section "AntiHiJack from the driver's door".
Note 2:
Theft protection program can be run as when you turn on "ghost equipment",
and when it is turned off (programmable).
Note 3:
Function «AntiHiJack from the ghost button" is programmatically enabled in
the factory settings. Delay time of failure simulation is 30 seconds.
AntiHiJack by GSM-channel
With the ignition on (engine running) program of protection against forcible car theft
can be started and reset via a phone:
1. Call the SIM-card number of the vehicle security system.
2. Enter a personal code in case of necessity.
3. Press the "asterisk" to switch to the remote control mode.
4. Guided by the voice prompts, press button "3" to activate or deactivate the protec-
tion AntiHiJack program or button "4" - for instant engine blocking.
5. Break the connection (see "System control via a phone").
Note:
Operation of "AntiHiJack by GSM-channel" protection program
and methods
of its reset are the same as described earlier in the section "AntiHiJack from the driver's
door".
Reservation
of engine starting
For vehicles with manual gearbox and not turbocharged engine, remote and automat-
ic engine start is possible only after arming with
reservation of starting:
1. Turn on parking or parking brake with the engine running.
2. Press and hold the remote key fob button
for one second – central door locking
opens and the system's LED starts flashing with the a frequency of 4 flashes per second.
3. Remove the key from the ignition - the engine will continue to run.
4. Leave the vehicle and close all doors and trunk.
5. Press the remote key fob button
- central door locking closes and the system's
LED will start flashing with a frequency of 1 flash per second.
6. When the delay time of switching off the engine expires (in the factory setting is 5
minutes) - the engine is turned off and the system goes into the armed mode with reserva-
tion of the subsequent engine starting.
M880
OPERATION MANUAL
13
Note 1:
Turn-off delay of the engine can be programmed in a fairly wide range -
from 0 to 30 minutes. Until the end of delay time, the system can be transferred into the
standard armed mode or returned to the mode of further operation of the vehicle.
Note 2:
If you are installing a "zero" delay - the engine will turn off immediately by
closing the central door locking. In this case, it will be impossible to leave the car with the
engine running for some time without a key in the ignition.
Note 3:
Cancel a reservation of engine starts is performed automatically when you
open any of the vehicle doors.
Engine starting via a remote key fob
Remote engine start is possible only in armed mode. For vehicles with manual
transmission and not turbocharged engine remote, engine start is possible only after arming
with reservation of engine starting (see "Reservation of engine starting").
1. Briefly press the remote key fob button
- the system will give sound signal, and
will switch on turn signals or parking lights for 5 seconds.
2. Not later than 5 seconds, briefly press the remote key fob button
- the system
will give short sound signal, produces an engine starting and goes into the armed mode
with the engine running - turn signals will flash briefly.
Note 1:
The system will be in the armed mode with the engine running for a time pro-
grammed by the installer. For an early engine stalling is necessary to press the remote key fob
button
while holding.
Note 2:
If engine starting will not be possible for any reason - the system will give 3
short sound signals and send the vehicle owner a SMS-message with information about start-
ing problems.
Engine starting via a phone
Remote engine start is possible only in armed mode. For vehicles with manual
transmission and not turbocharged engine remote engine start is possible only after arming
with reservation of engine starting (see "Reservation of engine starting").
1. Call the SIM-card number of the vehicle security system.
2. Enter a personal code in case of necessity.
3. Press the "asterisk" to switch to the remote control mode.
4. Guided by the voice prompts, press button "4" - the system will produce engine
starting and goes into the armed mode with the engine running.
5. Break the connection (see "System control via a phone").
Note:
If engine starting will not be possible for any reason – the system send the car
owner a corresponding SMS-message.
OPERATION MANUAL
M880
14
