ADJUSTING TABLE HEIGHT SCALE
The table height scale indicates the distance the table is from the cutting
circle (depth of cut). To verify and adjust the pointer, proceed with the
following steps:
1.
Run a piece of wood through the planer and stop the machine.
2.
Measure the thickness of planed end of the stock as illustrated In
Fig.43. If adjustment is required, loosen screw (A) Fig.44, adjust
pointer (B) and re-tighten screw (A).
ADJUSTING TABLE GIBS
In the unlikely event of the table developing unwanted movement during planning operation, the table can be
checked and adjusted by following these steps:
1.
With the table in the locked position, and a feeler gauge; measure the
gap between table gib (A) Fig.45 and table bracket (B). when set
properly the gap should be .005”
2.
If adjustment is required, loosen the three locknuts (C), and turn three
adjustment screws (D) Fig.45, as necessary to set the correct gap.
3.
Check and adjust the gap on the other side of the table in the same
manner. After adjustments are completed, tighten the six locknuts,
three of which are illustrated in (C) Fig.45.
4.
Raise and lower the table to its fullest range and check to see if the
table moves up and down without binding.
MAINTENANCE
Disconnect the machine from the power source.
Planer knives must be sharpened when use after numerous projects.
Periodic lubrication should be performed with grease or machine oil to assure the durability and accuracy of
the use of machine.
Always dust off dirt, chips, or any other particles left bqehind after operations have been completed.
FIG. 42
FIG. 43
FIG. 45
FIG. 44
Содержание MI-31662
Страница 19: ......