Magnum Industrial MI-31662, Руководство по эксплуатации

Страница: 12 / 34

3. Place the gauge block (A) Fig.37 on the table, directly under the
cutterhead (B). Use a .040” feeler gauge (C) and place on top of the
gauge block (A), raise the table until the cutterhead knife slightly
touches the feeler gauge (A) when the knife is at its lowest point
NOTE: Do not move the table any further until the adjustment is
complete.
4. Place the gauge block (A) Fig.38, under infeed roller (D). The bottom
of the roller (D) should slightly touch gauge block (A).
5. If adjustments are necessary, loosen locknut (E) Fig.39, and turn
adjustment screw (F) until the infeed roller slightly touches the top of
the gauge block (A).
6. Repeat the adjustments on the opposite end of the infeed roller in the
same manner.
7. Tighten locknut (E) Fig.39, after adjustments are completed.
LEVELING THE TABLE
The table is set parallel to the cutterhead at the factory and no further
adjustment should be necessary.
To check if the table is level with cutterhead, proceed with the following
Steps:
1.
Disconnect the machine from the power source.
2. Check if the cutterhead knives are correctly set as explained in
“Checking, Adjusting and Replacing Knives”.
3. Verify that the table is set parallel to the cutterhead by placing a
gauge block (A) Fig.40 directly under the cutterhead on the left hand
side of the table as illustrated. Raise the table until the gauge block
(A) Fig.40, slightly touches the cutthead.
4. Carefully move the gauge block (A) Fig.41, to the right hand side of
the table directly under the cutterhead. The gap between the table
and the cutterhead should be identical with left hand side.
5. If the table is not parallel to the cutterhead, lower boot (B) Fig.42,
which is located underneath the table.
NOTE: Table elevating
handwheel must be unlocked when making this adjustment.
6. Loosen lock screw (C) Fig.42, and with large pliers (D) turn adjustment
sleeve (E) as required until table is parallel with the cutterhead.
Tighten lock screw (C) after adjustment is completed and replace Boot
(B).
NOTE: The same adjustment can
also be made on the other side of
the planer if necessary.
FIG. 37
FIG. 38
FIG. 39
FIG. 41 FIG. 40