INSTALLATION
1.
Remove the fastening bolts from the machine to the shipping skid.
2.
Two lifting lugs are built into the machine, one of which is illustrated
in (Fig.3, A). These lugs can be used to mechanically lift the machine
using a forklift and lifting straps.
Note: The second lifting lug is at the back opposite end of the machine.
3.
Table can be lowered (Fig.3,B) to facilitate cleaning, loosen lock knob
(C) and turn handwheel (D) counter-clockwise until the table (B) is at
the desired height for cleaning.
4.
Loosen and remove screw from the top edge of the machine (Fig.4,
E). Rise the top cover as illustrated in (Fig.5, F) this step will
expose
the chipbreakers, and the cutterhead. Note: The top cover of the
machine is hinged to facilitated cleaning and adjustment procedure.
5.
Carefully remove the protective coating from the table, table rollers,
infeed rollers, anti-kickback fingers, cutterhead and cutterhead
knives. This protection coating may be removed with a soft cloth
moistened with kerosene.
Never attempt to use Gasoline, Acetone or Lacquer thinner, these
products will damage any painted area.
Caution: Extreme care should be taken when cleaning the knives,
as the cutterhead knives are extremely sharp.
6.
After cleaning, cover the table surfaces with a layer of quality paste
wax.
7.
Lower top cover and replace locking screw that was removed in step
4.
ASSEMBLING HANDWHEEL HANDLE
Thread handle assembly (A) Fig.6 into handwheel (B) and tighten locknut
(C).
CUTTERHEAD GUARD
Position the cutterhead guard (A) Fig.7, on the top cover of machine.
Align holes in cutterhead guard with holes in the top cover and fasten
with (six) 6mm-button head screws (B) as illustrated in Fig.7
FIG.3
FIG.4
FIG.5
FIG.7
FIG.6
Содержание MI-31662
Страница 19: ......