Magnetrol KOTRON SMART RF 805, Инструкция по установке и эксплуатации

Страница: 2 / 16

These units have been tested to EN
50081-2 and EN 50082-2 and are
in compliance with the EMC
Directive 89/336/EEC and Directive
94/9/EC for Equipment or protective
system for use in potentially explosive atmospheres.
2
UNPACKING
Unpack the instrument carefully. Make sure all components
have been removed from the foam protection. Inspect all
components for damage. Report any concealed damage to
the carrier within 24 hours. Check the contents of the car-
ton/crates against the packing slip and report any discrep-
ancies to Magnetrol. Check the nameplate model number
(Model number/approvals as per inserted separate sheet) to
be sure it agrees with the packing slip and purchase order.
Check and record the serial number for future reference
when ordering parts.
MOUNTING
Nameplate:
- partnumber
- amplifier
- serial n°
- tag n°
2 cable entries (one plugged): M20 x 1.5, 3/4" NPT or PG 13.5
Handtighten or use Size: 33 mm (1 1/8") or adjustable wrench
WARNING: Never mount or dismantle a threaded probe by the
upper mounting nut for the amplifier (a), ALWAYS use the lower
probe mounting nut (b).
KOTRON R.F probes
d2
min. 1" - 150 lbs
DN 25 PN 16
3/4"
1"
G1(1"BSP)
d1
d1 = d2
For replacing electronics only:
The electronic insert can easily be removed by loosening the 3 mounting screws
and unplugging the module. The probe wire is fixed to the PCB by means of a
spade plug.
Disconnect white probe wire always at the probe - never at the electronics (see
above).
(For installation details see bulletin BE50 - 125)
Bent probe
Guarded probe
Flexible probe
Probe with inactive sheath Stillwell probe
inactive sheath
Wrong
(b)
(a)