Magnetek FLEX MINI, Инструкция по эксплуатации

Страница: 23 / 27

Flex Mini System Instruction Manual
June 2015
Page 23 of 25
PB3 PB4
PB5 PB6
PB8 PB7
START
Type 3
STOP
PB3 PB4
PB5 PB6
PB8 PB7
PB2
ON
OFF
Type 2
PB3 PB4
PB5 PB6
PB8 PB7
PB2
Type 1
PB1
4. OPERATING PROCEDURE
4.1 GENERAL OPERATING PROCEDURE
Keypad Type 1:
The transmitter is powered on and operated by pressing any button on the
keypad (green blinks on Status LED). The transmitter goes into sleep mode
after 5 minutes of inactivity (buttons not pressed). Press any button to wake
up the transmitter and continue operation.
Keypad Type 2:
The transmitter is powered on by pressing the On/Off button once for up to
2.0 seconds (green on Status LED); the receiver main is also activated at the
same time. The Status LED will blink green every 4 seconds thereafter for up
to 5 minutes when no buttons are pressed (transmitter standby). After 5
minutes the transmitter will go into sleep mode. Press the On/Off button for
up to 1.0 second to wake up the transmitter and continue operation. Shut off
the transmitter power by pressing the On/Off button for up to 2.0 seconds
(red on Status LED and then off); the receiver main is deactivated at the
same time. The system will not work when pressing any buttons prior to
initiating the On/Off command (Status LED blinks 2 red).
Keypad Type 3:
The transmitter is powered on by pressing the Start button once for up to 2.0
seconds (green on Status LED); the receiver main is also activated at the
same time. The Start button becomes an auxiliary function thereafter. The
Status LED will blink green every 4 seconds thereafter for up to 5 minutes
when no buttons are pressed (transmitter standby). After 5 minutes the
transmitter will go into sleep mode. Press the Start button again for up to 1.0
second to wake up the transmitter and continue operation. Shut off the
transmitter power by pressing the Stop button for up to 2.0 seconds (red on
Status LED and then off); the receiver main is deactivated at the same time.
The system will not work when pressing any buttons prior to initiating the
Start command (Status LED blinks 2 red).
4.2 CHANGING TRANSMITTER BATTERIES
Change the transmitter batteries (“AA” alkaline battery x 2) by unscrewing the battery cover located on
the backside of the transmitter counterclockwise. During battery installation make sure the batteries
are installed correctly, with “+” to “+” charge and “–” to “–” charge. Also make sure the screw is
tightened after battery installation to avoid water, moisture, dirt, grease, or other liquid penetration.