Flex 8RS System Instruction Manual
December 2012
25 of 36
SYSTEM FUNCTIONS
TEST
JP
7
JP
6
JP
5
JP
4
JP
3
JP
2
JP
1
I-CHIP PORT
I-CHIP PORT
4.2.5 I-CHIP Programming Port
(Fig. 17)
The I-CHIP programming port located on the decoder module (refer to Fig. 17 above) inside the
receiver is designed for the purpose of transferring system serial number/ID code either from I-
CHIP to receiver or vice versa. If you wish to transfer system information from receiver to I-CHIP,
just insert the I-CHIP onto the programming port (JP6 jumper not inserted), wait until the Status
LED on the decoder module turned constant green (within 2 seconds), and then take the I-CHIP
out of the programming port (programming completed). At this time the I-CHIP should also
possess the same serial number/ID code as the receiver. If the Status LED on the decoder
module displays a constant red light after inserting the I-CHIP (programming failed), then you
must reinsert the I-CHIP one more time. On the other hand, if you wish to transfer system
information from the I-CHIP to the receiver, then you must first insert JP6 jumper prior to inserting
the I-CHIP, then wait for the green light to appear on the Status LED. At this time the receiver
should also possess the same system information as the I-CHIP. Please note that the receiver
unit must be powered in order to proceed with the programming.
Flash the receiver decoder board using either a spare I-CHIP or the system transmitter’s I-CHIP.
With power off, plug the I-CHIP into the I-CHIP port and put a jumper on JP6. Power on the
receiver and when status LED goes green, programming is complete. Power down the receiver
and remove both the I-CHIP and the jumper across JP6.
Serial Number (S/N) – 6 digit serial number set per project
Type – Set receiver type to 00 for standard receiver
AUX – Set to NOR
PWR – Set to 0
Timer – Set to 03
CH – 2 digit channel set per project (overwritten by dip switch settings)
FUNC – set to 000
4.2.6 Fuse Ratings
FUSE #
110 -
120VAC
220 -
240VAC
380 -
400VAC
410 -
460VAC
24VAC
42 & 48VAC
12 - 24VDC
F1 ~ F8
5.0A (clear) 5.0A (clear) 5.0A (clear) 5.0A (clear)
5.0A (clear)
5.0A (clear)
5.0A (clear)
F9 ~ F10
0.5A (blue) 0.5A (blue) 0.5A (blue)
0.5A (blue)
1.0A (red)
1.0A (red)
2.0A (purple)
