Flex 8RS System Instruction Manual
December 2012
29 of 36
8
3. Ensure the selected location has adequate space to accommodate the receiver (refer to Fig. 18 on
page 28).
4. For better reception, make sure the receiver is in an upright position.
5. Drill one hole (8mm in diameter) on the control panel or location where the receiver is to be
installed (refer to Fig. 18 on page 28).
6. Make sure the bolt is tightened after installation.
7. For system wiring please refer to page 27.
6.4 SYSTEM TESTING
1. Turn on the power source to the receiver and test the MAIN relay output by pressing the red
emergency stop button and observe that it properly opens and closes the mainline disconnect
contactor.
2. Test the operation of each function to ensure it corresponds to the transmitter direction labels or the
pendant it is replacing.
3. Test the limit switches (if any) to see if they are working properly.
4. If your new remote control is replacing an existing pendant, make sure it is completely
disconnected and placed in a safe location to prevent unwanted control commands.
