Flex 8RS System Instruction Manual
December 2012
7 of 36
2.8 BATTERY HANDLING
Use only batteries approved by Magnetek for the specific product.
Do not dispose of a battery pack in fire; it may explode.
Do not attempt to open the battery pack.
Do not short circuit the battery.
For intrinsically safe environments only use specified Magnetek intrinsically safe batteries.
Keep the battery pack environment cool during charging operation and storage (i.e., not in direct sunlight or close to a
heating source).
2.9 BATTERY CHARGING
For those transmitters equipped with battery chargers, please familiarize all users with the instructions of the charger
before attempting to use.
Do not attempt to charge non-rechargeable battery packs.
Avoid charging partially discharged rechargeable batteries to help prolong battery cycle life.
Avoid charging the battery pack for more than 24 hours at a time.
Do not charge batteries in a hazardous environment.
Do not short the charger.
Do not attempt to charge a damaged battery.
Use only Magnetek Telemotive approved chargers for the appropriate battery pack.
Do not attempt to use a battery that is leaking, swollen or corroded.
Charger units are not intended for outdoor use. Use only indoors.
2.10 BATTERY DISPOSAL
Before disposing of batteries consult local and governmental regulatory requirements for proper disposal procedure.
2.11 SPECIFIC SYSTEM WARNINGS
Below are some specific operating safety tips that should be strictly followed when operating a Flex 8RS system:
1.
Check the Status LED on the transmitter for any signs of low battery power (refer to page 33).
2.
Check the Status LED on the transmitter for any signs of irregularities (refer to page 33).
3.
Make sure the system is not set to the same channel as any other Flex systems in use within a distance
of 300 meters (900 feet).
4.
Never operate equipment with two transmitter handsets at the same time unless they are programmed to do
so.
