Flex 4EX2 / 6EX2 MRX CE Instruction Manual
November 2018
Page 37 of 44
1. For best reception the location of the receiver should be visible to
the operator at all times.
2. The location selected should not be exposed to high levels of
electric noise. Mounting the receiver next to an unshielded variable
frequency drive may cause radio interference. Always locate the
receiver as far away from variable frequency drive and electric
motor as possible.
3. Ensure the selected location has adequate space to accommodate
the receiver. If an external antenna is used, to avoid the possibility
of antenna damage always locate the receiver where the antenna
is free from any obstacles.
4. When installing an external antenna make sure the MCX jack
located on the RF/decoder board inside the receiver is connected
and jumper set to “EXT” position.
5. For better reception, make sure the receiver is in an upright position.
6. Drill four holes on the control panel, wall or location where the receiver is to be installed.
7. Make sure the screws are tightened after installation.
300 mm
Control
Panel
1
0
4
mm
Ő į
5 6mm
102
mm
