Magnescale MG10A-P1, Инструкция по эксплуатации

Страница: 77 / 132

(E)
29
MG10A-P1 / MG10A-P2
Details of command operations
ASCII code is used for all the commands. A command is
terminated by “
CR ” or “ CR ” + “ LF ”. (“ CR ”: carriage return; “ LF ”:
line feed)
• Select using communication setting switch No. 2. on main
unit.
OFF : “ CR ” + “ LF ” (factory setting)
ON : “ CR ”
• On the pages to follow, “ c
” and “
d
” are used to indicate the
value to be set.
• When inputting a setting, a numerical value inside the
assigned range must be selected: otherwise, the value will not
be set.
• If no polarity (+ or −) is input, it is construed as +.
[Data which is input ahead of the commands]
Data Selection range Symbol used in descriptions
Unit number 0 to F or
*
a
Module number 0 to F or
*
b
• 0 to F are hexadecimal numbers which are equivalent to 0 to
15 in the decimal system.
•
*
is used when the settings are to be set for all units or all
modules.
6-1-5. Operation Commands
List of operation commands
Command Setting item Remarks
R Load the data of all the channels.
r Load the data of specifi c channels.
P-P Switch to the peak-to-peak value mode.
MAX Switch to the maximum value mode.
MIN Switch to the minimum value mode.
REAL Switch to the current value mode.
MODE Set the measuring For details on how to set the
mode. measuring modes, see
section 5-4.
RCL Recall the preset value.
RES Reset.
(Zero reset/reference point setting cancel)
START Start.
P Set the preset value. For details on how to set this
value, see section 5-4.
CH Set the comparator For details on how to set
upper limit. this value, see section 5-4.
CL Set the comparator For details on how to set
lower limit. this value, see section 5-4.
SCN Set the comparator For details on how to set this
set number. number, see section 5-4.
PAU Set the peak value data update stop.
LCH Set the current value output data latching.
L Load the reference point.