Magnescale MG10A-P1, Инструкция по эксплуатации

Страница: 75 / 132

(E)
27
MG10A-P1 / MG10A-P2
„
Numerical value:
Fixed at 8 bytes : + or − sign followed by the data
(including decimal point)
[Example 1] For a resolution of 0.1 μm
: “−99.9999” to “ + 99.9999”
[Example 2] For a resolution of 10 μm
: “−9999.99” to “ + 9999.99”
[Example 3] In the event of an overfl ow, the count continues
but the leading character changes to “F.”
“−99.9999” → “−F0.0000” → “−F0.0001”
[Example 4] When an alarm has occurred, “Error” appears
: (“ ”,“ ”,“ ”E”,“r”,“r”,“o”,“r”,“ ”)
†
Data separate character:
1 byte “ ” (space) or 2 bytes “ CR ” + “ LF ”
Select using RS-232C command (factory setting: space).
z
Delimiter:
2 bytes “ CR ” + “ LF ” or 1 byte “ CR ”
Select using communication setting switch No. 2. on main
unit.
OFF : “ CR ” + “ LF ” (factory setting)
ON : “ CR ”
6-1-3. Communication Format
Communication data output format
Channel 0
Output data Channel 1
Output data Channel n
Output data Delimiter
[Example]
Header:
5 bytes (this diff ers depending on communication mode)
Byte 1 : Leading character ....................unit number
0 to F
Byte 2 : 2nd character ...........................channel number 0 to F
Byte 3 : 3rd character ......... mode Current value mode
: N
Maximum value mode : A
Minimum value mode : I
Peak-to-peak value mode : P
Byte 4 : 4th character ............................unit M (mm) I (inch)
Byte 5 : 5th character comparator
judgment value ....................Upper limit NG : U
Within range : G
Lower limit NG : L
When an alarm has occurred : E