Magnescale MG10A-P1, Инструкция по эксплуатации

Страница: 69 / 132

(E)
21
MG10A-P1 / MG10A-P2
5-4. Changing the Factory Settings
(RS-232C Commands)
Th e setup commands for RS-232C communication are used when
the factory settings are to be changed. Th e new settings will take
eff ect when the setup is ended by the close command.
Th
e settings established here are stored in the internal memory
where they are retained even aft er the power has been turned off .
Th
e unit starts up according to the new settings the next time
the power is turned on. See “6-1. RS-232C Interface” for the
communication specifi cations.
Note
It takes a maximum of about 3 seconds to save data aft er the
CLOSE command has been sent. Never turn off the unit’s power
during this time as the unit may cease to start normally.
5-4-1. List of Setup Command
Command Setting item
SETUP Start parameter setup.
MODE Set the measuring mode.
P Set the preset value.
CH Set the comparator upper limit.
CL Set the comparator lower limit.
SCN Set the comparator set number.
REF Set whether the reference point is to be used or not.
LCLR Clear the reference point setting (reference point
off set value).
STTERM Select the external start input function.
RSSEP Select the RS-232C data transfer format (separator).
RSFORM Select the RS-232C output data format.
RSTRG Select the RS-232C trigger or internal timer.
SCALE Select the scale unit (mm/inch).
CLOSE Close the parameter setup.