Magnescale MG10A-P1, Инструкция по эксплуатации

Страница: 62 / 132

14
(E)
MG10A-P1 / MG10A-P2
Push the spindle of the measuring unit upward by 1 mm or
more, and retract it.
Th e reference point lamp of the counter module stops fl ashing
and lights.
Push in at least 1 mm.
Align the measuring unit with the master object to be
measured.
2
3
Input the master value as the preset value using the RS-232C
command.
Note
Transmit the SETUP command, P command, then the CLOSE
command, in this order.
Th e reference point off set value is stored in the counter
module.
Once this value is set, the reference point will be set automatically
aft er the power is next turned on when the spindle of the
measuring unit is pushed upward by 1 mm or more. To set the
reference point again, clear the reference point off set value using
the RS-232C command, and proceed again from step
1 .
4-2-4. Reset
Th is function resets all the measured values to zero regardless of
whether the preset value is set.
Note
• Th
e reference point setting is also canceled when the reference
point is being used. Set the reference point again.
• If a reset input is supplied while the reference point is being
set, the reference point setting is canceled as soon as the reset
input is supplied.
4