Magnescale LY71, Инструкция по эксплуатации

Страница: 38 / 44

2-10
(E)
LY71
2. Applied Operation
2-16-9. Operating restart from an external device
Restart can be performed by an external signal.
Connections are required.
Ex. IN A : Input signal for counter display A
Ex. IN B : Input signal for counter display B
Ex. IN C : Input signal for counter display C
➔
Installation manual “4-3. Advanced Settings” (General-purpose input)
2-16-10. Setting a value input by Preset from an external device
This sets a value input by Preset from an external device. However, the value that is called is the first (No. 1)
of the three values.
Connections are required.
2-17. Clearing the Display
When an display is shown, pressing the key clears the display. However, the error cannot be
cleared if the cause of the error is not removed.
Differences from regular reset
In addition to the incremental value, the absolute value is also reset to zero. Therefore, to relocate the datum
point position, perform the procedure in “2-4-2. Relocation of the datum point position”. If the master
calibration function is set to ON, master relocation is performed, and the measuring unit must go past the
reference point.
2-18. Presetting Multiple Points
Up to three preset values can be saved.
1
Press the key.
........ A numerical value can be entered.
2
Enter a numerical value.
3
Press the key.
........ This switches to entry of the next numerical value.
Repeat steps 1 to 3 .