Magnescale LY71, Инструкция по эксплуатации

Страница: 37 / 44

(E)
2-9
LY71
2. Applied Operation
2-16-5. Sending the display mode to an external device
Connections are required.
∗
Counter display C is a reference display, and so output saving is not possible.
➔
Installation manual “4-3. Advanced Settings” (General-purpose input)
2-16-6. Relocating the datum point position with an external signal
The operation in “2-4-2. Relocation of the datum point position” can be used to relocate with an external
signal.
Connections are required.
Ex. IN A : Input signal for counter display A
Ex. IN B : Input signal for counter display B
Ex. IN C : Not available
➔
Installation manual “4-3. Advanced Settings” (General-purpose input)
2-16-7. Sending the reference point detected signal to an external device
When performing the reference point operation, the reference point detected signal can be sent. The signal is
not output even when going past the reference point unless the reference point operation is performed.
Connections are required.
OUT A1, OUT A2 : Counter display A output
OUT B1, OUT B2 : Counter display B output
∗
Counter display C is a reference display, and so output saving is not possible.
➔
Installation manual “4-3. Advanced Settings” (General-purpose output)
2-16-8. Operating the hold function from an external device
The hold function (Latch, Pause) can be performed by an external signal. This function is activated when
turned ON/OFF once, and it is disabled when turned ON/OFF again.
Connections are required.
Ex. IN A : Input signal for counter display A
Ex. IN B : Input signal for counter display B
Ex. IN C : Input signal for counter display C
➔
Installation manual “4-3. Advanced Settings” (General-purpose input)