MAGNAWELD monoTIG 160ip, Руководство пользователя

Страница: 15 / 56

15
www.magmaweld.com USER MANUAL | KULLANIM KILAVUZU
monoTIG 160ip
EN
Before plugging your machine to the electrical line, check the line voltage.
Figure 2 : Gas and Mains Connections
Figure 3 : Gas Cylinder - Regulator - Hose Connections
2.3.1 Mains Connection
2.3.2 Gas Connections
• Switch the machine to the position “OFF” “0” and insert the plug
into the socket.
• Switch on the machine via power switch. Observe that the
switch itself and the led displays in the front panel lits, also you
should hear the sound of the cooler fan.
• Secure the gas cylinder to a wall by a chain. To operate safety and get best results, use approved regulators.
• Open the gas cylinder valve few times in order to blow out any possible dirt or particles.
• Connect the gas regulator to the cylinder, make sure that the threading of the gas outlet of the cylinder and
the nut of the regulator match.
• Connect one end of gas hose to the gas regulator and connect the other end to the gas supply inlet. Open the
gas cylinder valve.
• Set the gas quantity with the pressure adjustment valve.
• Make sure that there are no gas leakages from any connection.
2.3 Connections for TIG Welding
Diameter of
Nozzle
(mm)
Welding
Current
(ADC)
Gas Debit
(lt / min)
1.0
1.6 6.3
9.5 30 - 70
30 - 150
6 - 8
6 - 8
Diameter of
Electrode
(mm)
Installation
TIG torch connection via CX79 TIG torch adaptor
• Thread the nut of the torch through the plastic body and screw to the torch plug tightly. Then place the torch
plug into the plastic body.
• Thread the L shape gas hose adapter through the hole on plastic body and screw it to the socket tightly.
• Connect the gas hose to the elbow union wiht the clamp tightly.
• Install the connector pins to the control cables of the torch.
2.3.3 Preparing the Torch Connections